Historic Repair Work at Remote Fixer
Browse our archive of completed remote control repairs. Showing page 136 of 159 (3,837 total repairs). We no longer list individual jobs — these are historic records.
Gazco / Mertik Maxitrol G30-ZRHTT-Z27 Repair
The remote seems to be working except it doesn't seem to be transmitting anything to the controller unit which controls the stove 'temperature' gauge so the stove ignores the remote. The remote was dropped on the floor just before it stopped working - perhaps there's an issue with the bit in it which transmits the information to the receiver?
View Details
Denon RC-1127 Repair
The buttons (eg power, source, volume up/down and mute) have slowly been getting worse over time and are now useless. As its the most used it would appear it has just worn out. No water or other damage.
View Details
TRITON TRITO-83309640 Repair
UNIT IS PARTIALLY WORKING BUT FASCIA HAS PERISHED MEANING SOME OF THE BUTTONS DO NOT WORK. THERE ARE 6 BUTTONS AND THE UNIT IS QUITE BASIC, IF IT COULD BE REPAIRED I WOULD NOT BE TOO BOTHERED ABOUT HOW IT LOOKS AS LONG AS IT CAN BE TURNED ON AND OFF. AT PRESENT IT WILL SWITCH ON BUT NOT OFF .
View Details
Telstyreisen ALR 9446 Repair
Case is damaged and as a result it works intermittently depending how hard you squeeze the case together, which has been held together by duck tape for a while now. I recently had to replace the battery which resulted in needing to open the case. Would really like to have the case replaced. As far as I'm aware there is nothing else wrong with the unit.
View Details
Marantec Repair
Battery compartment broken and . Battery will not stay in contact with connectors. Back cover missing. I have photo if you would like me to upload
View Details
Audio Pro 20121222 Repair
does not work from a distance, has to be right up to censer on speaker.
View Details
firmadoor GDO-4 Repair
remote will not power garage door red sensor does not light up anymore previously very unpredictable somtime would work after several attempts
View Details
Celebrity 5 pin dual Motor Repair
remote control is unresponsive the motor has been tested an has been found to be ok.
View Details
Hulsta 1.10-202 300J09R Repair
All buttons need to be checked as some do not work correctly or not at all.
View Details
PSE RC03B P1345A 03Y265060 151519 Repair
CERTAIN BUTTONS NOT WORKING (YELLOW & GREEN)I DON'T USE BLUE BUTTON
View Details
Hitachi RC5117 Repair
Not sure just stopped working .changed batteties still not working.
View Details
Vibradorm Bed Repair
Head and foot adjustment made by buttons on remote control. All UP controls OK, but Down control buttons have poor contact and have to be "waggled" to make them work. Red light shows when contact is made and bed adjusts as required. No problems with vibrators. I do not use them.
View Details
Vibredorm. Gmbh 2040046204 Repair
Does not connect to bed red light works on remote but does not connect to move bed
View Details
Art HCF1 6552020002 49/05 Repair
will not open the sofa recliner. bottom on the left side
View Details
Mertik Maxitrol G30 ZRRS (receiver) G30 ZRHSO (remote control) Repair
Using the two buttons to increase gas flow works perfectly, but the button to decrease gas flow often also increases the gas flow. It does eventually decrease the flow of gas after frequent attempts. I've noticed that the red light on the receiver does not always respond when the decrease gas flow button is pressed.
View Details
Brilliant Ledge, Trade Name 116 Repair
Right hand side lower button not working, Left hand side lower button temperamental
View Details
Mertik Maxitrol G30 Repair
Remote LED indicates the remote is sending a signal and the LED on the receiver briefly lights up indicating it is receiving the signal but the signal isn't maintained long enough or isn't strong enough to turn the fire on/off or up/down.
View Details
Naim Unitiqute Repair
Remote was dropped and now not working - on inspection it looks like battery connector on circuit board has broken,but I could be wrong!
View Details
Brilliant gas fire Repair
Inside the remote control, there is a bog standard replaceable battery that provides power to the remote control. The battery is connected to the remote control by two wires, a Red wire and a Black wire. The black wire has become detached. I believe this has resulted in the remote control no longer working as the fire works fine when switched on manually.
View Details