Historic Repair Work at Remote Fixer
Browse our archive of completed remote control repairs. Showing page 78 of 159 (3,837 total repairs). We no longer list individual jobs — these are historic records.
Gazco G30 Repair
Buttons all work ok Transmitter only works at very short distances from receiver (less than 5cm)- probably transmitter transducer failure
View Details
enduro EM4444 Repair
It started the mover then failed to work. Having changed the batteries the ON button does not work though the green light flashes when putting in the batteries.
View Details
Garage Door PDT KF04-433RC Repair
Just stopped working - thought it was the battery but new battery didn't help. Suspect it possibly went through the wash in a pocket.
View Details
Yamaha RAV 253 WE 5860 EU Repair
Power Button stand by Not functioning volume ? hit and miss
View Details
Truma SE Repair
the on/off switch rather troublesome to get the remote to work. Also battery compartment springs not looking right.
View Details
Adjustamatic Repair
The remotes do not work at all. We suspect that the wires attaching to the remote from the cable have come out due to the remotes constantly being left to hang and the cable at the base of the remotes after taking the weight of the remotes, has become loose. We do have two other remotes which are working but the cable is coming off at the base. Hoping you can fix without reprogramming. The remotes are roughly 12 years old.
View Details
Pdt Kf04-433rc Repair
The four black sensor pads are worn and can just about be activated by taking it apart and pressing them but they do not work by pressing the outside casing buttons, green, red, green and grey
View Details
Dewert 34.826 Repair
All the buttons on the bottom of the bottom of handset. The bed is unable to be made to lie flat.
View Details
Mertik Maxitrol G30-ZRHS Repair
I dropped it on the floor and it has not worked since. I replaced all the batteries, remote and attached to the gas valve) and tried it again yesterday. The red light on the remote came on but it did not communicate with the valve controller and the flame size did not change.
View Details
Aura Landscape Legendfires Repair
Top left button not working. Bottom right button not working. <br /><br /> Top right button working intermittently. Bottom left button working intermittently. <br /><br /> Note: Two left buttons must be pressed simultaneously to ignite fire.
View Details
Mertik Maxitrol G30 ZR Repair
job ref:3795-4419 <br /> Remote tested by you and not found to be faulty. Now sending gas fire unit. Fire can be turned up but not down.
View Details
Mertik Maxitrol G30 - ZRRS Repair
The remote seems ok, but the receiver even with new batteries doesn't respond, correctly. Reduces the flame, within the fire, but does not increase it when the additional button is pressed
View Details
SIT Repair
Not operating fire. No lights showing on any button press despite new Batteries. Fire working manually.
View Details
Reich 227-10131 Repair
The red light comes on for 'on' but the motor mover doesn't respond. I need you to check the remote first before things become very expensive!
View Details
Celebrity Repair
Further to our telephone conversation today I think there may be a loose wire in my mums remote for her recliner chair
View Details
GROHE Repair
NO signal from remote to shower unit. The second exterior remote work fine but this has no temperature control only controls shower unit on/off but this show shower unit works ok
View Details
Mertik Maxitrol G30-ZRHSO (Sender) Repair
Receiver will only show red light when sender is 1 cm away in either increase or decrease mode, and sometimes not at all. I have tried new batteries and checked battery voltages.
View Details