Repair Work Carried Out At Remote Fixer

KF04-433RC Repair
This remote was the spare, and when needed no activation light went on when the buttons were pressed. When I replaced the 2 X CR2016 batteries, the activation was illuminated permanently.

Infinity Repair
The spring on the right hand side in the battery compartment is loose and doesn’t hold the battery in place right so the remote stops working.

Gazco (Mertik Maxicontrol) G6R-H4T5-GA Repair
Battery indicator shows low battery even with new battery. Will not communicate with Gas fire.

Mertik Maxitrol G6R-H4T5-GA Repair
Mertik Maxitrol G6R-H4T5-GA remote control used for Gazco fire is faulty. The black wire that connects to the battery terminal is broken. It was previously soldered but didn’t work for long before breaking again. Not sure if the red wire is also now faulty but remote doesn’t work. Last time it did the fire went on then we couldn’t turn it off which was dangerous and had to cut gas off at the mains. Hoping you can repair this somehow. Thanks

Flavel Repair
Holding the remote control brings on the green “Unlock” symbol but no other buttons work. When putting the remote down, the green led stays on permanently. The fire ignites perfectly when operated on it’s local controls.

BMW-9320240-03 Repair
The remote doesn’t appear to be getting any power from the batteries. Installing new batteries made no difference.

Edn MK II Gas Fire Repair
The signal is not very strong from the remote, i have managed to test the receiver with a cloned signal from this remote and it works fine.

Mertek Maxitrol G30-ZRHTT-Z27 Repair
Remote appears to be operating continuously even though no buttons are pressed and the antenna graphic is not showing on the LCD screen. The battery is drained very rapidly (new one put in, BATT indication within 2 days). Also remote appears to be getting hot inside: it's reading on the screen much higher than we know the room temperature to be.

Infinity 780FL Repair
Won’t switch fire on .. very intermittent at first , now lights up but won’t switch fire on/ off

Dru Repair
Metal connection to one of the battery points has snapped. You have previously welded this before but it has come apart again when changing battery. All other buttons etc are intact and working.

GAZCO Repair
NOT IGNITING THE FIRE THE FIRE IS STARTING WHEN SWITCHED ON MANUALLY BUT IT SEEMS THAT THE REMOTE CONTROL IS NOT WORKING.

Gazco / maxitrol Repair
Remote operates “up” button with constant red light showing on both remote and receiver units. The “down” button produces steady red on the remote but rarely shows anything on the receiver (and when it does it is intermittent). Changing batteries in both units does not change the position.

Gasco Repair
Intermittent fault on remote , not sure if it is the remote, so I’m happy to pay for your time to look at the remote Just having to go through the process of elimination

Truma Mower Repair
Truma Mower toimii 80% sti. Eli yhteys katkeaa. Siirtäjän keskusyksikkö on vaihdettu kaksi kertaa, tulos aina sama. Kahdeksankymmentä kertaa sadasta toiminta OK. Silloin kun häiriö on vaunua voi siirtää noin puoli metriä, jonka jälkeen yhteys katkeaa. Kaukosäätimen virtakytkin on varmaankin kulunut useista yrityksistä johtuen