Repair Work Carried Out At Remote Fixer
Gliderol TM-27Mhz N12282 Repair
Was working intermittently Put a new battery in thinking that was the fault Now not working at all
Vibradorm 9425 2.2 B Repair
Cause of the problem seems to be the cable.
Mertik Maxitrol Repair
Does not functionG6R-H4TV21-Z22
ACii AirCon Repair
Battery terminals missing and battery cover
The battery connector has come away where the battery pushes onto and is now missing. The remote was dropped. The remote was in full working order prior to this but if you’d be kind enough to check fully
metik maxitrol g30zrhso Repair
a wire has come lose in side cotrol
PDT KF04-433RC Repair
UNIT HAS STOPPED WORKING NO LIGHTS COME ON EVEN AFTER REPLACING BATTERY
Copland CDA 266 Repair
The remote control not working. When pushing remote control buttons, blinking green light, for some buttons, right side, green light not blinking.
Proof vision Water proof Repair
Does no work
Denon RC-899 Repair
Dead. Remote has small LCD display and this does not show anything. Tried new batteries etc
Yamaha Wj55360 Repair
Seems dead - all buttons I sent it to you two years ago and you repaired it for the same reason, but the fault has recurred.
SIT 4 button Gas Fire Repair
Only one button seems to be working. (Top left) Fire works correctly with manual controls. And two different new batteries tried with remote.
Verine Vertex FL700NG Repair
Fire will not start. Was working but had to hold remote very close to the receiver. Spoke to Martin on the phone and we established that some of the buttons were not working at all and some very intermittently.
Focal point Repair
Trouble with putting batterie in
POWRTOUCH GEN 1 Repair
Won’t turn on, it should turn on from the adapted button (I never installed it) on the bottom and the green light should alight.
Buttons not working and screen gone blank.
No longer works. Discussed with Martin
Carver M606846 Repair
On / Off button sometimes reluctant to operate. Forward motion button fails to operate most of the time.
Aurora Victoria Electric Fireplace RCS-01c Repair
Buttons do not work. They stopped working even with new batterys
Mertik Maxitrol G30 ZRRS Repair
Sensor/battery holder not responding to open gas valve instruction when remote operated (exactly as per description on this site. New batteries fitted to sensor and remote handset.
Mertik maxitrol G30 Repair
The button to lower the flame does not work and slow working signal to operate the gas flames in general.
Gazco Mertik Maxitrol G30 Repair
Unable to set time via dual press of small buttons.
Able to switch on via Auto button.
Manual increase button flakey.
Manual decrease button usually works, but starting to miss sometimes.
Thermostatic control appears to function normally.
Mertik Maxitrol Repair
Remote control works fine, it’s the control box that isn’t working. Changed the batteries and still the red light on the controller box does not illuminate.
Bellfire Mertik maxitrol B6R-H8TL3W Repair
Remote control will no switch on. Screen has gone blank. Remote was dropped on floor.