Repair Work Carried Out At Remote Fixer
Horizon Bell fire Repair
Remote isn’t working and has a rattling noise when you shake it. Parts on inside seem to loose and disconnected
HSL Chair Repair
all buttons work apart from the foot rest button which i beleive is a common fault
Gazco - Mertik Maxitrol G30-ZRHSO-Z26 Repair
Remote dropped on stone fire place. No longer works
Cocktail audio X10 Repair
Power button works as dose the volume and some direction arrows, the OK button and others do not.
Mertik Maxitrol G30-ZRRSB Repair
The receiver will only work the gas valve one way. The remote control is functioning normally
Truma Mover S Repair
The battery terminals are corroded and this causes contact to be intermittent. Everything works properly when in action. It is just the terminals that need to be cleaned/replaced.
Magiglo Repair
I have changed the batteries of the receiver but is not lighting up neither respond to the remote
Metronome Technology Repair
Nothing happens! I checked the batteries - all OK.
Gazco Repair
Drains battery in 2/3 days even if not used will only controle the receiver when there is a gap of about 1 inchbetween them
Hülsta Twinmaster Fernsteuerung Repair
Es ist eine Batterie ausgelaufen und hat die Leiterplatte beschädigt. Die Fernsteuerung zeigt keine Reaktion mehr.
Homcom Foldable treadmill Repair
It is not working at all, need it to start and stop treadmill
Gazco Electric Repair
It doesn't work have changed batteries, fire flickers when main switch is turned on at wall. It did work last winter.
Celebrity Repair
Please Re- wire the Remote Control unit, Ref; TH27-2039-002
G6R-R4AM Repair
The receiver won’t communicate with the remote to turn the fire on.
Gazco & Mertik Maxitrol G6R-H4T5-GA - G6R-R4AM Repair
Battery has been replaced in remote but lpw battery indicator still flashing. Receiver does not appear to be receiving any signal from remote, no beeps or movement or gas valve when buttons pressed. Voltage at receiver from battery pack with new batteries was 5.91V.
Mertik maxitrol Repair
After changing batteries ready for winter, the receiver isn’t working. I assume it’s the receiver as the remote led shines when buttons are pressed, but not the receiver led. All worked fine throughout last winter!
handicare Repair
i have two remotes, one is working ok but second one neither buttons work. this has been happening for a while, i did get it temporally to work by pressing both buttons simultaneously and then the button required, now nothing. i have changed batteries and checked they have charge, also cleaned terminals.thank you.
Linn Repair
A couple of years ago, you have repaired my Linn Classik CD.CA Handset. Now it is in trouble again. I hope you will have a look at it. Thanks in advance for your efforts. Best regards
Infinity Repair
The ok or confirm button does not work. Besides scrolling up and down no other buttons work.