Repair Work Carried Out At Remote Fixer
Mertik maxitrol Repair
Receiver not operating when remote is pressed. Remote lights up so appears to be working.
Brilliant Ledge 30 Repair
Stand- by and Low buttons not working. Stand-by hard to press. Cannot light the fire with remote - manual operation not available.
Adjustamatic Repair
The cable requires replacing. I will be honest. I have had a go my self by cutting back The bad cable and soldering the wires back. The wires are very delicate and I feel they need securing correctly to the connector block rather than soldered
Celebrity Repair
Celebrity Furniture Hand Control, Dual Motor Riser Recliner 8 Pin TH7R-2039-006. The wires are exposed and not working
Celsi Repair
remote doesn't work at all. A child has thrown it and it sounds loose inside.
HSL riser recliner TH27-2039-009 Repair
Curly cable has damaged outer - everything works OK though, although would be grateful if you can inspect/clean the internal switch contacts as some appear less responsive than others. I understand that you may need to replace the cable with a straight lead rather than a curly one.
Flameritefire Repair
Have put new battery and bulbs in. Light is on on all buttons but still not working
BFM Verine Orbis Repair
No function, the remote is dead. It should wake when held in the palm of your hand but nothing happens. One of the batteries leaked and the remote now no longer functions, although it looks fine except for some small corrosion around the battery contacts.
Gutmann Capa Repair
The signal doesn’t work. We can switch the extractor fan in manually but not with the remote.
Craftmatic Repair
The coil chord insulation is shredded, but rhe controls are working
Sherborne TH29-2050-006 201408290573 Repair
CURLY CABLESHEATH HAS CRACKED AND IS IN NEED OF REPLACEMENT
Clima pro 2 glow-worm Repair
Screen completely blank Corrosion top left battery compartment area
JLHDA918 Repair
Remote control not responding. Changed batteries and no joy. It has been temperamental since purchase … but I got it working until I had to replace the batteries.
Quad 77 System Console Repair
Control started being intermittent, cured with a reset, but has now locked up totally. This may be to do with the rechargeable batteries (soldered onto the board) failing - this was the issue last time it was repaired by Quad (who no longer service them). I think that the internal NiCad batteries were replaced with NiMH batteries at this service.
Tecalemit Repair
not working at all, power going to pcb but nothing functioning on the remote.
HSL / Celebrity Repair
Rise Recline chair remote. Button to lift leg rest is not working
Gazco Mertik Maxitrol G30-ZRHSO-Z26 Repair
The light is flashing but it’s not working the fire
HSL TH27-2039-009 Repair
All buttons (especially the two smaller ones to the left as you look at the remote) either do not work when depressed or require a lot of pressure in order to work. Also, in attempts to detect what the issue was I have removed the rubber from the casing which will need fitting back in (the rubber lining will be sent with remote)