Repair Work Carried Out At Remote Fixer
MPT-40 Repair
Rubber buttons are old and worn out, meaning it's almost impossible to activate the remote which operates both the immobiliser and central locking systems
VELUX Repair
Device not powering up from batteries (swapped out old ones, by no improvement). Only powers up when connected via USB. Possible signs of corrosion to interior.
Dungs Repair
No responses on LED on any of the buttons, tried cleaning battery terminals as they were slightly corroded. Also tried cleaning the PCB with just a damp cloth but no joy. I did see a very dim lit LED but hardly visible unless in the complete dark
Bellfires Repair
The remote turns on when a battery is in situ, but doesn't connect to the receiver. Have troubleshooter and reset the receiver but the remote fails to connect.
Belfire b6r-h8tl3w Repair
It fell and went dead. I went to a repaircafe but they were not able to revive it.
Garog Garage door opener Repair
This opener is intermittent. At the moment the light doesn't come on when pressing the left hand blue button (to open the garage) and therefore it won't open the garage.
BFM Europe Repair
Caseing has distorted over the last couple of weeks. Looks as though caused by heat and the technical team at BFM suggest it may have been caused by overheating battery or shorting on the board.
Darley Repair
The remote does not function as intended. None of the buttons work but the motor on the bed in the salon is fine as other remotes do function when plugged in.
TEMPUR HS SPLINE 65044 Repair
As far as I can tell its the raising and lowering that has the fault, originally it was intermittent but now the light flickers (instead of solid) and nothing works up or down.
Infinity Repair
One of the battery terminals (enclosed) has become detached and it's no longer working.
QUAD Repair
I have a problem to reset remote control. Manual says: To RESET, put the remote control into the Charging Cradle with "SOURCE" key pressed. When you release the SOURCE key, “RESETS” appears in the display beside a key. The remote control can now be removed from the Charging Cradle. After you briefly press the SOURCE key, the display shows "press any key". After pressing a key, the initialization process starts and, after a short time, all attached devices should be represented in the remote control display, on the "top level menu". All goes in line with manual recommendation, but on step "press any key" it show error message and initialization process is not started. This issue appeared after batteries change, therefore I suggest I didn't changed it in a proper way. Hope you can find a root cause and repair it.
HSL chair Repair
Foot rise button and back rise button not working. Only button working is the chair riser.
Mertik Maxitrol G6R-H4T5 Repair
Hello, as discussed on the phone just now, the battery icon at the top-right of the display flashes, indicating low battery, but the problem was not addressed by replacing the battery. From a look at your website this appears to be a common issue you have fixed in the past relating a faulty 7133 regulator.
POWAKADDY ROBOPKADDY Repair
it was working fine then i went away for 3 months abroad and came back to it not working.
Flamerite electric fire YCT 100 Repair
Control not working and power light not illuminated on the controller