Repair Work Carried Out At Remote Fixer
Powerwheel Repair
Intermediate problem to put handset on sometimes comes on immediately but more often it doesn't (new batteries)
Westin RC001 Repair
Light button works but the fan on / off and + / - does not work, think something the circuit board is loose and therefore only works from time to time
Gazco Mertik Maxitrol Repair
The button to turn the gas flow up does not work. The bottom button (to turn the gas flow down) does work so I know its not the receiver on the fire itself.
Sherborne Repair
Irratic behaviour, sometimes buttons don't seem to work at all. Trying to work out if the remote is faulty or the controller is faulty.
KF04-433RC Repair
This remote was the spare, and when needed no activation light went on when the buttons were pressed. When I replaced the 2 X CR2016 batteries, the activation was illuminated permanently.
Infinity Repair
The spring on the right hand side in the battery compartment is loose and doesn’t hold the battery in place right so the remote stops working.
Gazco (Mertik Maxicontrol) G6R-H4T5-GA Repair
Battery indicator shows low battery even with new battery. Will not communicate with Gas fire.
Mertik Maxitrol G6R-H4T5-GA Repair
Mertik Maxitrol G6R-H4T5-GA remote control used for Gazco fire is faulty. The black wire that connects to the battery terminal is broken. It was previously soldered but didn’t work for long before breaking again. Not sure if the red wire is also now faulty but remote doesn’t work. Last time it did the fire went on then we couldn’t turn it off which was dangerous and had to cut gas off at the mains. Hoping you can repair this somehow. Thanks
Flavel Repair
Holding the remote control brings on the green “Unlock” symbol but no other buttons work. When putting the remote down, the green led stays on permanently. The fire ignites perfectly when operated on it’s local controls.
BMW-9320240-03 Repair
The remote doesn’t appear to be getting any power from the batteries. Installing new batteries made no difference.
Mertek Maxitrol G30-ZRHTT-Z27 Repair
Remote appears to be operating continuously even though no buttons are pressed and the antenna graphic is not showing on the LCD screen. The battery is drained very rapidly (new one put in, BATT indication within 2 days). Also remote appears to be getting hot inside: it's reading on the screen much higher than we know the room temperature to be.
