Recent Repair Jobs
mertik maxitrol g30-zrhso-z26 Repair
The remote seems to be working, but the receiver circuit board or cables are temperamental and, ultimately don't function
The remote got wet. Dried out and when replacing the battery the green light flashes, but then stops, and none of the control buttons work. Seems to have shorted somewhere
Batteries have been replaced but still not functioning - no red light showing when buttons are pressed
Riviera UR203 Repair
Recently started working intermittently and then just stopped working altogether.
Copreci Mmb22600 Repair
Hi. Remtote seems ok, but didn't communicate with the control bix anymore. Control box was still working in manual mode, till a few weeks. I've tried to check for a bad connection, and sometimes the pilot light was lighting again when I moved the control box a little. Now nothing happens anymore. I would like to send you both remote and controlbox for checking. Is this possible? Controlbox ref is Copreci UCMB 22600
Iglu waterproof tv Repair
Menu button isn’t working so I’m unable to retune the television
Mertik Maxicontrol G30-ZRRS Repair
The remote works for setting the flames on/higher but not off/lower
Arcam Solo Repair
Entire unit not working
Mertik Maxitrol G30-ZRRS Repair
Not sure of fault. Batteries inside were dead and signs of corrosion of copper (green deposit) at or near battery terminals plus possible battery leakage. I scraped off corrosion, fitted new batteries, and it worked ok for a while. However, it had failed an hour later. The receiver unit light does not illuminate using a functioning remote (not the one I'm sending for repair. Maybe I disturbed terminals to maybe corrosion of joints?
Pioneer AXD7613 Repair
Volume buttons up and down
VIBRADORM CRT/6-2-NL Repair
Bed up at top and bottom or both not working
mertik maxitrol Repair
very erratic, some times works for a sec then don't
Acoustic Solutions SP151 Repair
Remote was working on all buttons and just stopped after a bit of prolonged usage (typing track names in). Did camera test and no output from IR LED, tested LED with multi meter and dead both ways (+to+ -to-, +to- -to+). I have replaced the LED myself with a new one which now tests good(should be in the right way round but please check) but this has not fixed the problem.
Climapro 2 Repair
Front screen error message:
Installer menu access
Access Code: 0
But I can't change the number on the front, nothing seems to change/work
Not response. Probably broken transistor.
Enduro purple line Quottro Repair
Remote not operating mover
Gazco 8590 Repair
The Send butto has fallen out - just does not work - csnnot turn on fire without it.
LG 6711R1P072B Repair
Buttons not working
Wires have become detached from remote point
It was left outside in the rain now. It won't switch on
Paragon Focus Repair
Left hand side button (*2) variable / weak
Glow worm Climapro2 Repair
Thermostat no longer gives the correct reading on the display; it displays a hotter temperature than the room actually is eg stuck at 30c or Two dashes where the digits should be = therefore the combi thinks that the desired heating temperature has been reached and won’t turn the central heating on. Remote / Display works fine other than that.
Mertik Maxitrol G6R-HIO Repair
Increase Flame (top right) and Pilot Light (bottom left) buttons not working
Mertrix Maxitrol G30-ZRRS Repair
The remote operation was intermittent and then stopped working. Have taken it apart and there are no obvious signs of loose joints or burning. The red light works on sender. Light is okay on receiver, when tested separately, but not when sender operates. I know the motor on gas fire works as I can operate it directly from the batteries.