Repair Work Carried Out At Remote Fixer

Reich caravan motor mover Repair
Intermittent on/off button and general service

HSL Repair
one button is not working properly and the wire covering is falling apart

MERTIK MAXITROL G6R H4T5 GA Repair
BATTERIES ONLY LAST FOR A WEEK OR SO EVEN IF REMOTE IS NOT USED. FINALLY THERE IS NOW NO POWER TO THE LCD SCREEN. THERE APPEARS TO BE A LOOSE BLACK WIRE INSIDE THE SET.

Glow-worm Climapro Repair
Buttons don't seem to be working and the control no longer connects to the boiler

Infinity 480 FL Repair
I can only set the time, thereafter none of the other buttons work.

Mertik Maxitrol Repair
lost communication to fire whilst in use. won't pair with fire using reset button and down arrow. Batteries replaced, still no joy. Borrowed unit pairs and works fine.

Bose RC9 Repair
Remote not communicating with base station and thus the surround, speaker mode and volume buttons aren't functioning.

SWISSFLEX Repair
The OUTSIDE of the cable (with 7 very small cables inside) is broken almost everywhere. Despite this, in the moment the system still works well.

Mertik Maxitrol Repair
Remote is not connecting with gas fire to switch on the fire.

MPT1340 Garage Repair
Black button does not move, no click or movement when pressed.

Burley Repair
After dropping the remote control on the floor the remote functions intermittently but with great difficulty, it only has one button

KEYTON MMS-2000ST Repair
FAULTY/WORN SPRINGS IN BATTERY COMPARTMENT (meaning batteries are not fitting correctly and connection is poor)

Elica Repair
The remote works when plugged in but doesn't hold the charge. I think the rechargeable battery needs replacing. Thanks.

NAD Repair
Buttons in the center of the remote not working - likely battery leak

Gazco Repair
Remote control not reading room temperature. Temperature reads - - all other functions work as normal (suspect faulty thermocouple??)

Firmadoor FMD-1 Repair
No response at all from the controller, red light should turn on and the garage door should then open/close - controller appears “dead”.