Envisua Repair

Some times it works some times it doesn’t Power volume and menu

Sherborne 5 button Repair

The wires are broken at the base of the remote

Celebrity Repair

Intermittent fault believe cable is U/S as badly damaged, reason for the suspicion is it will work in certain positions

Martel Maxitrol G6R-H4T5-GA Repair

Remote thinks battery is dead when it’s news so remote doesn’t work to turn on gas fire. I saw you fixed one before with same problem. Thanks.

Gazco gas fire G6R H4T5 GA Repair

Wires broken when attempting to change battery.

MPT-40 Repair

Potentially the LED is broken, and if anything can be done to improve the buttons, then that would be great. Many thanks!

Gazco G6R-H4T5-GA Repair

After a period of no use, changed the battery and turned on the gas fire. On turning down the flame the remote became unresponsive and displayed battery empty and the display behaving erratically.

Sleepeezee Repair

Buttons not working

Mertik maxitrol Repair

Black wire come loose from where battery attaches

Gazco Marlborough Repair

Item not talking to the fires receiver

Velux Repair

Both not working, not been used for several years

HSL Repair

Buttons not working, in particular foot raise.

Linear Repair

New battery in remote control but not working.

Sherborne Repair

Power going to the box but no green light for the remote and it is not working.

Qvis Repair

Complete failure

John Lewis (Koell) Cooker Hood Repair

Remote stopped working

Teac RC-858 Repair

Entire remote control stopped working, all buttons.

Celebrity chair lifter 5 button Repair

Just dead

HSL 8 PIN 4 BUTTONS Repair

The lift button for feet is not working.

Mertik Maxitrol Repair

All the buttons work but I have to open the flap at the front of the fire to expose the electrics to activate the pilot, I can’t do it from the other side of the room like I used to, I have to get right up close to the fire to make the mechanism work to light the pilot. Same thing when I press the ‘off’ button. It’s like the signal from the remote is not strong enough to connect with the fire unless it’s up really close. Fire lights ok when I turn it on and goes off ok. Hope this is enough detail

Sirius BeFree S6/S 433.92 Mhz Repair

Intermittent, not able to switch off

Mertik Maxitrol Repair

Loose weight in the back

Adjustamatic beds Repair

The shield that protects the wire as it enters the handset broke exposing the individual wires. Eventually one or two of these wires broke and the handset would no longer work. As you will see, there has been an attempt to repair this handset without success. Unfortunately, the person who attempted the repair didn’t realise there was a screw holding the top of the handset and the screw housing was broken. The wires had to be cut as some were broken anyway and the ends have been attached to new connectors (spare connectors included). When the handset was tested, it still did not work, so I searched the internet and found you. I hope you can make it work. Note that the reset button was not put back when the handset was reassembled. I include it, so it can hopefully be put back

BM Test Equipment Repair

Not functioning at all, power issue