Historic Repair Work at Remote Fixer
Browse our archive of completed remote control repairs. Showing page 87 of 318 (7,633 total repairs). We no longer list individual jobs — these are historic records.
E&P Caravan Levelling System Repair
After caravan being in storgae for 6 months the remote controller stopped working properly. Changed 9 volt battery (checked voltage of new battery and old battery both over 9v. Re- Paired remote controller to the main system sucessfully. After turning on the system the only buttons on the remote controller that work are: The Power On button and the offisde centre ram intermittently. The following LED's work correectly too. The centre green LED that represent a level caravan, The right centre ram LED, the Legs down warning LED and the withdraw front wheel LED. Page 16 of the manual identifies these as: 3, 4, 5, 13 and 15.
View Details
Pure Evoke Repair
Batteries need replacing and tinted plastic 'window' needs to be re affixed.
View Details
Flamerite ARC 102 Repair
Does not power up at all, changed the batteries but still doesn’t work
View Details
Sherbourne Repair
Cable needs replacing, not sure about buttons could you check those also please.
View Details
Gliderol Repair
New battery installed but only works intermittently and at VERY short range. My other remote now works as it should.
View Details
Datatool Repair
One button needs replacing and also needs a new gp27a battery. Fob works erratically which I suspect is due to low battery voltage and collapsed button.
View Details
Glow Worm Climapro 2 Repair
Remote kept saying batteries needed replacing constantly, even when they were replaced the message was still there. Screen has now gone (mostly) blank, flicks on occasionally but not long enough to actually use remote.
View Details
Quattro enduro Repair
Just not working with mover lights up and bleeps just dose not connect.
View Details
HomeCom A90-252V70 Repair
Treadmill remote only has 3 buttons - can push buttons in but no red light. When take back off remote, the battery is loose and doesn’t fit snuggly (so may be the issue)!
View Details
Mertik Maxitrol Repair
Remote comes on with a nee battery, but the batter indicator will show half full and then quickly go down to 1 bar and flash as if it needs replacing. Remote was working even with this issue until a few days ago when now it has stopped communicating with the fireplace receiver. Remote still powers on though.
View Details
Adjustamatic Ascot chair Repair
Signals to hand controller are hit and miss. Not able to use massage unit.
View Details
Wurlitzer OMT 184/F91 Repair
The volume low button and the mute button are not working. The others are Ok....so far.
View Details
Truma SE Repair
On/off toggle switch missing. Case damaged and doesn't clip together. Batteries leaked swapped out for new ones did work for a short while but springs now snapped off on battery contacts
View Details
DATATOOL MOTORCYCLE ALARM Repair
transponder fob is not talking to the alarm unit on the bike. The red light within the fob does not uluminate, 2 x new batteries have been installed 16/3/24 but still not working. when red lights decides to work, fob works and activates the alarm system
View Details
Vibradorm Repair
Remote dropped onto floor and now no buttons are working i.e. none producing any response from bed. Also, only half of the buttons cause the red power indicator to light when pressed.
View Details
Recliner Repair
One of the wires coming out of the controller had broken. My friend has done a 'cobbled together' fix, but if you can fix it permanently, I would be delighted.
View Details