Recent Repair Jobs
Mission e3asr Repair
Remote suffered leakage damage from old batteries. Contacts cleaned and appeared to work but has since become defective (infra-red checked with camera and contacts checked with multi-meter).
Sony RM-LP205 Repair
For a good year the remote buttons are not fully working, i can turn on / off ok but i can not turn Volume up/down. Screen lights up ok and i can scroll through sound options and select ok but that's about it ,It did work (the volume) for a couple of day recently then stopped again .
Mertik Maxitrol G30-ZRHS Repair
With new batteries fitted, both the the receiver and transmitter buttons illuminate. However whilst the remote will adjust the flame height up, it will not reduce it. The fault is exactly as outlined on your website in Job Time line Ref 1828-2146. The RECEIVER is a Mertik Maxitrol G30-ZRRS.
Buttons not working
No reaction from bed controller after testing on two alternative bed units
Mertik Maxitrol G30-ZRHSO-226 Repair
Dropped on stone floor. Now only works if held about 1cm from fire unit.
Dungs M0-IRT-1-1 | 231304 | prod.code: G10 Repair
On/Off switch doesn't work, red light with higher and lower still works
screen does not come on/will not operate the fire, have tried new batteries, old batteries went all furry have cleaned the terminals.
CONTROLLER IS WORKING BUT CASE IS SLIGHTLY DAMAGED
RDT KF04 433RC Repair
We have 2 garage door openers this one has stopped working, we have replaced batteries to see if that was the fault but still not working. When we replaceded the batteries we turned off the power supply for 30 seconds. None of the buttons are working even though the red light comes on.
Battery corrosion causing middle terminal spring to break off and corrosion of other terminals.
Gazco MMB22600 80895108 Repair
Now Power - look badly corroded with battery terminal missing
I have old remote which I can send you I've been looking for years to get replacementplease help
Carver Caravan Motor Mover Repair
Does not work after changing batteries
Enduro Caravan motor mover EM1032 Repair
Remote control does not work, when power button is pressed twice red light should come on, remote not communicating with transiever
SOMFY SYSTEM II Repair
The Remote LED indicating it is in "programming mode" does not illuminate when paper clip is used to depress program switch. I cannot program Somfy LT30 motor to set raised and lowered position.
The IR raise and lower functions fine, but program function does not work
As discussed on the phone, batteries left in over winter, and battery terminals corroded. Currently working but would not like to rely on it.
REMOTE WILL NOT POWER UP WITH RED ON/OFF BUTTON
bose rc35t-l Repair
None of the buttons appear to work and the battery cover is missing
Does not communicate with main unit and is very worn!
Paragon fire Repair
The buttons on the remote have stopped working and no longer igniting our Paragon gas fire. All batteries have been changed and still not working. The top left button is the one tjat has totally stopped working the other 3 are intermittent. Many thanks.
Mertik Maxitrol Repair
Remote handset fitted with new batteries only works when placed within 25 mm of receiver G30- ZRRS