Repair Work Carried Out At Remote Fixer
Paragon Repair
Small button on the left hand side does not come on and when it does the remote will not ignite the pilot light
METIK MAXITROL G30 ZRRS Repair
WILL NOT TURN FIRE ON TOP BUTTON NOT WORKING ON REMOTE
HSL recliner Repair
Controller had developed intermittent fault with the buttons but has now become none functional. I checked power supply and other connections and cannot find any other fault.
Legendfires Repair
The left hand buttons that control ignition no longer work ( dont light the led ) or send signal to the fire .The right hand buttons work most of the time but also require checking.
Mertik maxitrol Repair
The cord attaching to the battery seems broken, the remote does not switch on.
Gazco Repair
Battery indicator constantly showing even when I change the battery to new and intermittent connection to the fire place
Canton Repair
Remote has stopped working for the Canton Speaker. No apparent tissue with the speaker though I cannot be sure. Have replaced remote batteries but to no effect, hence problem with remote control assumed to be the problem.
Gazco Mertik maxitrol Repair
Remote will not turn the fire up but intermittently, it will turn it down.
Quad 99 Pre-amplifier Repair
Not transmitting. Checked using 'phone camera, no output from LED. Just stopped working part way through playback, batteries checked, fine.
MERTIK MAXITROL G30-ZRRS / G30-ZRHSO Repair
Remote seems to work as light comes on, however the light at the fire end receiver does not, with no engagement at the fire control. New batteries were tried but no change.
ACii Repair
The On/Off button is not working - possibly a loose connection? The battery terminals are slightly corroded. The IR light cover is missing.
HULSTA Repair
The bed does not respond in any way whatever button is pressed. (Independent of which of the two scenarios below is the current one). Removing the batteries and installing new, fresh ones and/or unplugging the power from the bed in 5 minutes does not help. Additional - Every second time I put in batteries all lights in the "display" lights up whatever button I press. And the next time I take out the batteries and put them back in and press any button all the lights, except the one indicating the head position, turns on and stay on forever (that is until i remove the batteries again - after 30 minutes ++).
Nu-flame N3 Repair
Battery connection failed. Also all buttons are only intermittently working.
Quad 99 Pre-Amp Remote 99 Pre-Amp Repair
Remote just stopped working, tried new batteries to no avail, no buttons appear to be working.
Att Repair
Not working after being sat for a year. The battery is brand new what is in it. Please can you supply a back battery cover if can be repaired.
Adjustamatic Repair
The lights on buttons come on. Press the button and nothing happens. Initially,it would overun. The cable possibly has a break in it.where it connects to the hand set. I can see this, possibly shorting. The remote buttons light up but when pressed nothing happens. Before some times if cable is disconnected from the handset it would work. But now just the buttons ĺigĥt up.
Truma Repair
Batteries leaked and damaged wiring, tried to temp fix but wires too small to solder Needs new wire and soldering
Mertik Maxitrol Repair
The battery low level warning indicator on the remote control screen is always displayed even when a new battery is inserted into the device. The remote control device seems to have power from the battery as other values and icons are displayed on the remote control screen. The remote control device fails to connect with the gas fire and the fire can not be operated.