Historic Repair Work at Remote Fixer
Browse our archive of completed remote control repairs. Showing page 131 of 318 (7,633 total repairs). We no longer list individual jobs — these are historic records.
MMB22600 Repair
Batteries leaked and battery connectors have rusted off whilst removing batteries
View Details
Glow Worm Repair
Thermostat no longer gives the correct reading on the display; it displays a hotter temperature than the room actually is eg stuck at 30c or higher therefore the combi thinks that the desired heating temperature has been reached and won’t turn the central heating on. Remote / Display works fine other than that.
View Details
Mertik Maxitrol Repair
Just spoken to engineer. It’s dead, I have replaced the battery but still the red light on the top left does not come when pressing any of the buttons. Consequently the fire will not switch on remotely.
View Details
DOOYA DC174A Repair
Water ingress several times. This time dry out not fully successful. Led blinks and runs down 12v battery overnight. Remote will still operate in a fashion.
View Details
Gazco Maxitrol G30-ZRHSO-Z26 Repair
Remote works if placed within 1cm of receiver. Zero response if further away. So the system works but either the remote is providing very weak signal or the sensor has too low sensitivity
View Details
Creda Repair
All buttons stopped working, not sure if batteries leaked and corroded the circuit board. Tried cleaning inside then switched on and worked but couldn't switch off.
View Details
Flamerites YCT-100 Repair
The flame button at the top left is missing (has broken off) so there is a hole on the remote where the button is supposed to be. I need a replacement button for this part I think. I can get the fire on but only when I poke something on the bit inside that the button normally presses onto.
View Details
Gazco Repair
I put in a new battery into the remote and the red light continues to stay on. I can’t use the buttons and can’t turn the fire on or off. Normally red light on remote only shows when the button is pressed.
View Details
Unilift Verine MPT1340 Repair
Not working. Garage control works.Would be delighted if you could replace the Fob
View Details
Nu-Flame Repair
It does not cause the fire to light up. The red LED does not light up. The battery in the remote control is over 9 Volts and the batteries in the receiver are all over 1.5 Volts
View Details
Gazco studio 2 Repair
When buttons are pressed no beeps. No signal sent to the fire. So doesn’t switch on or off. Changed batteries. Still not working. Then noticed the black wire in the battery cable has broken off from the solder.
View Details
Stewart golf Repair
Some buttons not working, seems to be Left , back , stop and speed 3 / 4 Bottom screw bracket
View Details
Merik maxitrol Repair
Gas fire not responding. Control shows flashing low battery despite have full new battery inserted.
View Details
Celebrity Repair
Curly wiring has become frayed, and disabled for safety, would like to replace the wiring and plug. (I understand there will be no 'curly' wiring available, straight us fine). GK
View Details