Historic Repair Work at Remote Fixer
Browse our archive of completed remote control repairs. Showing page 224 of 318 (7,633 total repairs). We no longer list individual jobs — these are historic records.
Pioneer CU-CLD097 Repair
it did work before maybe the terminals need a bit of a scrape with eg a small screwdriver. might be bad connection
View Details
mertik maxitrol g30-zrrs Repair
The receiver in the fire is not registering the 'up' command from the remote control and is not opening the gas valve as required. Both buttons register as operational on remote, they both illuminate the LED on the remote. The receiver illuminates with the 'down' command from the remote but not with the 'up' command
View Details
Bang & Olufsen Repair
Suddenly stopped working. No apparent output. Batteries changed but no improvement.
View Details
Celebrity Repair
The bottom left button {foot rest} works but is very hard to press... I presume the contact is worn... The others seem OK but I would appreciate it if you can check and replace any contacts that seem excessively worn
View Details
Mertik Maxitrol G6R-H4T5–GA Repair
1. A while back the P9 battery clip became loose so I spliced in a new clip<br /><br /> 2. Even with a new battery shows battery low and won’t operate fire - could be the voltage regulator chip problem .<br /><br /> If you could replace the battery clip properly and diagnose the battery charge / regulator fault I would appreciate it .
View Details
Autoglide Repair
Accidentally left in pocket and put through washing machine and tumble dryer. When battery inserted light stays on
View Details
Quattro e go Repair
Reverse and left top button not working, I have removed batteries to send in post
View Details
Mertik Maxitrol Repair
Batteries have been removed. With battery the controller power light works. With batteries the receiver power light does not work. When attached to the gas fire the controller -receiver does not make the gas fire control operate.
View Details
PowerWheel Repair
Was working fine and simply stopped functioning. Prior to this I noticed all the red lights adjacent to the movement symbols were flashing suggesting a replacement battery. I did replace and it stopped completely.
View Details
Velux Repair
Battery Compartment near battery spring terminal is cracked. As a result the batteries disconnect often in use.
View Details
Ego - enduro Repair
Remote not working when on button is pressed twice within 1 second, should be a solid green led as per instructions. Remote not paired with control unit
View Details
Ng Automation 09/15 TXP868N013 Repair
Hi, you have fixed our remote controls on a couple of occasions and I wonder if you can help this time. The 'casing' that the battery sits in has come away at one side and needs soldering. It works some of the time, but when the contact is lost, we need to open the remote up and put it back in place again.
View Details
Wharfedale Repair
Following our telephone conversation,the volume buttons don't work and there is split in the rubber
View Details
Velux KLR100 Repair
The back of the remote doesn't fit as it looks like it was melted (before I bought the house!) but it was working just fine until I changed the batteries. Now some of the buttons aren't working but some are? Enough buttons are not working that I can't connect it to the skylight it matches with.
View Details
Sherborne Touch Stop Repair
The Cable going into the handset has a tear in it causing the remote control unit to have a mind of its own
View Details