Historic Repair Work at Remote Fixer
Browse our archive of completed remote control repairs. Showing page 25 of 318 (7,633 total repairs). We no longer list individual jobs — these are historic records.
Gazco Mertic Maxitrol G30 - ZRHSO Repair
Similar to last years fault (Jan '25) the fire does not always respond to flame start or increase.
View Details
TRUMA Repair
Unit works fine most of time. Then the green light goes off and it does not respond. Moving switch on/off a few times and it's working again. Then sometimes it does not turn off. The green light stays on, so I have to remove a battery. Cleaned battery contacts and sprayed it with switch cleaner but still same. On/off switch seems a bit stiff at times.
View Details
Carver Repair
Will power up only 2 left buttons working if you try to use up or down or right side buttons shuts the remote down
View Details
Falmec Black FAL-105080053 Repair
The + buttons on both of the controls are not working. Looks like they have been used a lot, but each control has only lasted no more then 2 years.
View Details
HSL rise recline chair Repair
Button for footrest operation faulty, has left the footrest unable to be retracted.
View Details
MAHA Repair
Remote has power, power button rubber missing, casing damaged, unit does not communicate with shaker plates. Checked functionality of spare and that communicates with shaker plates so must be a problem with this remote.
View Details
Gazco Repair
I dropped the remote from about 5 feet onto a ceramic floor after which it stopped communicating with the Studio Inset Electric 150 fire. I changed the battery but still no functionality.
View Details
![Maxitrol - Gazco [G30-ZRRSB] + G30 - ZRHSO-Z26 Remote Control Repair](https://remotefixer.co.uk/newgallery/23593/front.jpg)
Maxitrol - Gazco [G30-ZRRSB] + G30 - ZRHSO-Z26 Repair
The equipment is fairly new [ ~ 2021/2] - it just stopped working. The batteries were clean and new. Not sure which part is faulty - The remote or the reciever. Hope you can help.
View Details
Gazco Mertik Maxitrol G30 ZRHTT Z27 Repair
Further to our telephone conversation, all seems OK with the remote except the emitter. The receiver green led lights up when fingers are rubbed across its surface, so assume the receiver is OK.
View Details
gazco mertik maxitrol Repair
the back of the control has warpped as it was left on top of the fire. the remote seems to be working fine but I just need a replacement case.
View Details
Gutmann Repair
Even though I replaced the batteries, this remote is not turning on and off the fan or light
View Details
HSL Repair
Started off with just one or two not working, they felt sticky etc. The fault has gradually meant the whole keypad doesn’t function
View Details
Mertik Maxitrol G6R-H4T5-GA Repair
When new battery installed, temperature and time symbols show but battery symbol shows battery as flat and no other buttons work. Fire will not respond even though ir sender signal is permanently on. New receiver unit fitted by Gazco engineer about 12 months ago (batteries replaced recently) but remote has been dropped since.
View Details
Celebrity Furniture recliner chair Repair
One cable broken - result is that back of chair will still recline but cannot be raised. Footrest raise and lower work as they should.
View Details
Faber misty Repair
Does not operate the up and down flame .i don’t think any signal is coming out of remote.
View Details
Valor Repair
Left batteries in remote which leaked & no longer works with new batteries . Fire doesn’t work without the remote
View Details